It claimed it is connected to NETGEAR04 which is the correct router.īased on this, I think the problem is with the router, the Cannon think it's connected.
But I don't see the cannon printer.ħ) I printed out the network connection of the Cannon printer. Besides I use the new password that I set to link with another laptop to prove I successfully changed the password.ĥ) I unplugged the power cord of the printer to let it reset, then went through the procedure, still no luck.Ħ) I type "" on the address bar and look for what is connected onto the wireless router. So I know I did it right in changing the password of the wireless access point. When it restarts, the two will reset and recheck and communicate.
#Resdt pixam mx922 to new router drivers#
But still not working.ģ) I connected the USB and updated the MS and XPS drivers to the printer and still not working.Ĥ) I even tried redo the setup using the password came with the router, it can't even connect. .Canon MX922 Try turning off both the computer AND the printer. Both times the printer came back and said it connected to the access point. Turn on the Canon Printer and connect it with a.
#Resdt pixam mx922 to new router install#
I tried holding the WPS button while the printer was searching AND I tried release the WPS button after pushing OK. Connect To Wifi Router Without WPS Install Canon Network Device Setup Utilities and start it on your device. I followed the instructions using the front panel of the printer.ġ) I pushed Manu and choose wireless setup.Ģ) I made it search for available wireless access point and it found my NETGEAR04.ģ) I entered in the password using the front panel of the printer and the printer came back and said "connected to the access point".īut I still cannot talk to the printer through wireless connection.Ģ) I use the push button option by holding the WPS button of the wireless router and push OK on the printer. My issue is setting up the wireless connection to the Cannon MX922 all in one printer. and I got both my laptop connected wirelessly to the router. I entered what I thought it is but wont accept. When I did it requested my pass phase that I apparently set when a bough the printer about a year ago. I was having no success and then read some place that I needed to change a setting on the canon. I just bought the Netgear AC1200 router, I followed the instruction of typing "" in the address bar, logged in and created my password. I have a new IMAC that Im trying to connect to my Canon PIXMA MX922 wireless.
0 kommentar(er)
